This is a ranty introduction to the electronic load project – photos, circuits and more will be available in part 2 next week!

So…I’ve been torturing power supplies (and to a lesser extend: batteries) for ages. Usually to check their health status by comparing the current peak performance to the claimed values in the datasheet. Once you see voltage rails dropping where they should not, it’s time for a replacement of the unit, or in case of specialized PSUs, for a swap of the electrolytic caps.

But the crudity of my testing always bothered me – hooking up power resistors, measuring voltage and current, manually connecting and disconnecting the DUT, never hitting exact performance figures because of the limited selection of torture devices I had around. […]