Tag: fan

The slightly more silent Ender 5 Plus (#E20F3)

Well, since the printer is running just fine, I used it to make some quality-of-life upgrades to it.
The bottom lid that covers PSU, all the mains wiring and the rest of the electronics has been removed and replaced by a 2 part print (due to size). Several reasons for that: a) Four of the six screws are covered by the additional aluminium frame, so it’s difficult to remove if properly fastened, b) if left unscrewed (which isn’t much of a load problem on the remaining two screws since it is sandwiched anyway), the ends of the large metal piece would be free to vibrate and resonate, c) the stock 40mm fan close to the driver board is terribly noisy and pointless in terms of air throughput, so I would have swapped it anyway. […]


Post #100 HP 6644A refurbishment (#P14)

Not that anybody cares, but this is actually post number 100 already. I prepared something else that failed (to be reported!), so this one has to do instead ;)

My “lab” power supply situation is ageing and often no longer up to the task, think of LEDs north of 35V or anything that takes more than one amp at voltages that cannot be provided with common computer supplies (3.3V, 5V, 12V, 19/20V) easily. So this is part one of the refresh.

I bought a HP 6644A power supply around six weeks ago off eBay, at 245€ including shipping and rack mounts via best offer. […]