Well, since the printer is running just fine, I used it to make some quality-of-life upgrades to it.
The bottom lid that covers PSU, all the mains wiring and the rest of the electronics has been removed and replaced by a 2 part print (due to size). Several reasons for that: a) Four of the six screws are covered by the additional aluminium frame, so it’s difficult to remove if properly fastened, b) if left unscrewed (which isn’t much of a load problem on the remaining two screws since it is sandwiched anyway), the ends of the large metal piece would be free to vibrate and resonate, c) the stock 40mm fan close to the driver board is terribly noisy and pointless in terms of air throughput, so I would have swapped it anyway. […]
[…] now has an extensive heat sink that covers a significant part of the card. SAS2308-8e (from #P34F1) for […]