Tag: stl

MikroTik wAP ac door jamb bracket (#P16)

$ThingsIWantedToDoForALongTimeButDidntUntilIPaintedMyLivingRoom++;

When upgrading my laptop to the QCA9880 3x3ac card, I had the need for an 3x3ac access point. I went for the MikroTik wAP ac at the time, my first dedicated AP, as I always was a FritzBox AIO dude. In the card review I said I wasn’t planning on in-depth reviewing the AP, but I still need to scratch a little on the surface here, literally.

The AP is sitting next to the excellent FritzBox 7362SL and in fact is sharing the power supply with it. As the MikroTik is a PoE device, it doesn’t have a fixed input voltage; instead, it’s a 11-57 V wide input (“12W max”). […]


DIY USB and SATA panel mount connectors (#P13)

Next batch of connectors incoming! (yes, I’m onto something)

I bet most of you are familiar with USB panel mount connectors, which (I guess) are a by-product of the slot mounted USB ports of PC mainboards in the late 1990s, early 2000s. Back then, boards had none or few USB ports on their back I/O panel, but often one or two available via pin header. So people obviously needed some slot adapter for them, something like this:

If you slap on a different connector on the other end and omit the metal bracket, this is basically what you get these days when buying USB panel mount connectors. […]


Mellanox ConnectX-3 3D printed brackets (WHL #42F1)

Looks like I got a project out of the 10GbE card thing

I have to admit that I was wrong in that post – the 3D model of the bracket over at servethehome doesn’t entirely fit the ConnectX-3 MCX311A. It’s for the higher-end dual cards (that I knew) with QSFPs (that I didn’t check). These are larger in physical footprint, so the bracket does fit by chance, but there’s empty space towards the PCIe connector. Also, because of the dual port architecture, these have their second mounting point shifted up higher, which means the second mount doesn’t even meet the PCB. […]